Can anybody tell me steps in installing wince os on mini 2440 ?

I have  mini 2440 board which came up with qtopia and later it was
formatted by my friend .NOW When i turn ON the mini 2440 it shows blank
screen .Initially i set up the environment for Friendly ARM mini 2440 board
on Ubuntu Linux 11.10 Host. I have minicom installed on my Linux PC  .when
i powered up board it was detected .in minicom asking to enter selection: i
am using dnw.exe using wine tool in Linux but its not detecting mini 2440 
..showing USB X...My final goal is to install the wince 6.0 on mini 2440
and would like to interface camera with it ,can anybody tell me what steps
i need to follow?

Hello,
There are two switches on board. 1. Power 2. NOR/S2 Switch (same like power
sitch).

Do foll. steps to connect mini 2440 to PC-
1.  power off your device.
2.  keep NOR/S2 Switch towards NOR. (its printed besides of switch).
3.  connect your device to PC using USB and serial port.
4.  power on device.
It will show blank screen on device and on PC it will bring connection
wizard. Choose Install automatically. 

Done.

Still if you are facing any problem please comment back.
Thanks,
Abhi